Simple Methods To Install A New MP3 USB Car Radio In Mazda 6

Are you a proud owner of a Mazda6 and are you looking for ways to upgrade the radio in your car? Then you will find this article helpful because this article will show you the how to remove the radio from a mazda6. For upgrading the radio in any car, the first step is to remove the radio from that car. It is actually quite easy to remove the radio from a high end car like Mazda if you follow the steps exactly as it is provided here. This tutorial is applicable for the Mazda\’s manufactured from 2003 to 2008.

For completing this task you will require a socket wrench, pliers and a screw driver.

Put the gear in the neutral position, set the parking brake and turn off the engine. After following these steps, open the hood of the car and disconnect the wire from the negative terminal of the battery. It is absolutely necessary that you disconnect the battery from the car before proceeding to remove the radio from the car. If the battery is not disconnected from the car then there may be short circuiting or electrical shocks. So make sure that you follow this step for your own safety.

For removing the gear shift knob rotate it in the counter clockwise direction. After a few rotations you will find the knob loosening; after loosening it remove the gear shift knob. Now remove the console from the car. You will find that the console extends to the ashtray. After removing the console you will find a couple of screws located in the underside of the climate control panel. Remove both the screws by rotating them in counter clockwise direction, with the help of a screw driver.

The glove compartment is opened to gain access to the side-mounted bold of the radio. The sides of this compartment are squeezed simultaneously, and are made to be dropped down. Once this is done, the screws that are seen can be removed.

You will find that the radio and the climate control are mounted on the same assembly. Loosen the entire assembly so that the whole setup can be removed. The air vent covers are included in the panel. Remove this cover. Turn the cover upside down. There will be twelve screws located on the cover. These screws are responsible for mounting the climate and the radio controls. Remove all the 12 screws with the help of a screw driver. Once all the screws are removed, the radio can be removed from the car.

After the radio is removed, do the above steps in the reverse order to assemble the parts. The dash is placed and all the screws are screwed back. The gear is then shifter in to the park mode. The battery of car is again reconnected. The negative wire is again placed on the battery and tightened.

This article therefore throws light on all aspects of removing the battery and the radio. It is essential to remove the battery to prevent any case of short circuit in the car while working on this removal. Now you know how to remove the radio from Mazda 6.

Learn more about Autoradioblende. Visite the Author\’s page where you can find more details about radio mounting kits and what it can do for you. Click here to get your own unique version of this article with free reprint rights.